Huawei Quidway NetEngine80E Configuration Manual page 702
Universal service router, ip routing
Hide thumbs
Also See for Quidway NetEngine80E:
- Configuration manual - reliability (1432 pages) ,
- Configuration manual (341 pages) ,
- Installation manual (169 pages)
Advertisement
HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
As shown in
IS. This example assumes that you know the configuration method and no details are provided
here.
Step 2 Configure PIM-SM.
# Enable multicast on all routers and enable PIM-SM on all interfaces except GigabitEthernet
1/0/0 on Router A. The configurations on Router B, Router C, Router D, and Router E are similar
to those on Router A and are not mentioned here.
[RouterA] multicast routing-enable
[RouterA] interface gigabitethernet 2/0/0
[RouterA-GigabitEthernet2/0/0] pim sm
[RouterA-GigabitEthernet2/0/0] quit
# Enable IGMP on the interface through which Router A is connected to hosts.
[RouterA] interface gigabitethernet 1/0/0
[RouterA-GigabitEthernet1/0/0] igmp enable
[RouterA-GigabitEthernet1/0/0] igmp version 3
# Configure a C-BSR and a C-RP. Set the service range of the RP on Router D and specify the
locations of the C-BSR and the C-RP.
[RouterD] pim
[RouterD-pim] c-bsr gigabitethernet 1/0/0
[RouterD-pim] c-rp gigabitethernet 1/0/0
# Run the display multicast routing-table command to view the multicast routing table of a
router. The multicast routing table on Router C is as follows:
[RouterC] display multicast routing-table
Multicast routing table of VPN-Instance: public net
Total 1 entry
00001. (192.168.3.2, 224.31.31.31)
Step 3 Configure an MPLS RSVP-TE tunnel.
# Configure Router B.
[RouterB] mpls lsr-id 2.2.2.2
[RouterB] mpls
[RouterB-mpls] mpls te
[RouterB-mpls] mpls rsvp-te
[RouterB-mpls] mpls te cspf
[RouterB-mpls] quit
[RouterB] interface gigabitethernet 2/0/0
[RouterB-GigabitEthernet2/0/0] mpls
[RouterB-GigabitEthernet2/0/0] mpls te
[RouterB-GigabitEthernet2/0/0] mpls rsvp-te
[RouterB-GigabitEthernet2/0/0] quit
[RouterB] isis 1
[RouterB-isis-1] cost-style wide
[RouterB-isis-1] traffic-eng level-2
[RouterB-isis-1] quit
# Configure Router C.
[RouterC] mpls lsr-id 3.3.3.3
[RouterC] mpls
[RouterC-mpls] mpls te
[RouterC-mpls] mpls rsvp-te
Issue 02 (2014-09-30)
Figure
7-11, assign an IP address and the mask for each interface and enable IS-
Uptime: 15:03:04
Upstream Interface: GigabitEthernet2/0/0
List of 1 downstream interface
1:
GigabitEthernet1/0/0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 IS-IS Configuration
677
Hide quick links:
Advertisement
