HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
5.16.12 Example for Configuring OSPF GTSM
This part provides an example for configuring OSPF GTSM. Detailed operations include
enabling GTSM on each router and specifying the valid TTL range of packets.
Networking Requirements
As shown on the network shown in
Router A, Router B, and Router C.
Figure 5-17 Networking diagram of OSPF GTSM
Area0
Configuration Roadmap
The configuration roadmap is as follows:
1.
Issue 02 (2014-09-30)
ip address 10.2.1.2 255.255.255.252
#
interface Pos2/0/0
link-protocol ppp
undo shutdown
ip address 10.3.1.1 255.255.255.252
#
interface LoopBack0
ip address 5.5.5.5 255.255.255.255
#
bgp 20
router-id 5.5.5.5
peer 10.2.1.1 as-number 10
#
ipv4-family unicast
undo synchronization
network 10.3.1.0 255.255.255.252
peer 10.2.1.1 enable
#
return
GE1/0/0
10.1.1.2/8
Network
RouterD
Configure OSPF.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure
5-17,routers run OSPF and GTSM is enabled on
Virtual Link
POS1/0/0
GE3/0/0
192.168.1.1/24
10.1.1.1/8
POS2/0/0
192.168.2.1/24
RouterA
Virtual Link
Area1
5 OSPF Configuration
RouterB
POS1/0/0
192.168.1.2/24
POS2/0/0
192.168.2.2/24
RouterC
399