Configuring The Delay For Transmitting Lsas On The Interface - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
ospfv3 timer retransmit interval [ instance instance-id ]
The interval for retransmitting LSAs to the adjacent routers is set.
The value of seconds must be greater than the time taken to transmit a packet between two
routers.
----End

6.3.5 Configuring the Delay for Transmitting LSAs on the Interface

It takes time to transmit OSPFv3 packets on a link. Therefore, a certain delay is added to the
aging time of an LSA before the LSA is sent.
Context
The LSA ages out in the LSDB of a local router instead of in the transmission process. You need
to set the delay for an LSA before sending it. For a low-speed network, this configuration is
necessary.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
ospfv3 trans-delay interval [ instance instance-id ]
The delay in transmitting LSAs on the interface is set.
----End
Issue 02 (2014-09-30)
NOTE
Do not set a value which is too small, for the interval between LSA retransmissions. Otherwise, unnecessary
retransmissions may occur.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 OSPFv3 Configuration
413