Enabling Ospfv3 On An Interface - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
In the format of an IPv4 address, a router ID is a 32-bit unsigned integer that uniquely identifies
a router within an AS. The router ID of OSPFv3 must be manually set. If no router ID is set,
OSPFv3 fails to run normally.
When manually setting the router ID, ensure that the router IDs of any two routers in an AS are
different. When multiple processes are enabled on a router, it is necessary to specify a unique
route ID for each process.
To ensure the stable running of OSPFv3, you need to allocate router IDs and set them in network
planning.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ospfv3 [ process-id ] [ vpn-instance vpn-instance-name ]
OSPFv3 is enabled and the OSPFv3 view is displayed.
Step 3 Run:
router-id router-id
A Router ID is set.
----End

6.2.3 Enabling OSPFv3 on an Interface

For an interface with multiple instances, you need to specify which instance of the interface is
enabled in the OSPFv3 process when enabling OSPFv3 on the interface.
Context
After enabling OSPFv3 in the system view, you need to enable OSPFv3 on the interface. Because
an interface has multiple instances, you need to specify which instance of the interface is enabled
in the OSPFv3 process when OSPFv3 is enabled on the interface. If no instance ID is specified,
the value defaults to 0. The same instance must be enabled on the interfaces between which the
neighbor relationship is set up.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
Issue 02 (2014-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 OSPFv3 Configuration
408