Configuring Ospfv3 Bfd Parameters At Process Level - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Step 3 Run:
quit
Return to the system view.
Step 4 Run:
ospfv3 process-id
The OSPFv3 view is displayed.
Step 5 Run:
bfd all-interfaces enable
BFD for OSPFv3 is enabled to establish a BFD session.
By default, BFD is disabled at OSPFv3 process level.
----End

6.10.3 Configuring OSPFv3 BFD Parameters at Process Level

After enabling BFD for OSPFv3, you need to configure BFD parameters in the OSPFv3 process.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ospfv3 process-id
The OSPFv3 view is displayed.
Step 3 Run:
bfd all-interfaces { min-transmit-interval min-transmit-value | min-receive-
interval min-receive-value | detect-multiplier detect-multiplier-value }
OSPFv3 BFD parameters are configured.
You can skip this step. The default interval at which BFD packets are transmitted and the default
detection multiplier are recommended.
The parameters are configured based on the network status and network reliability requirements.
A short interval at which BFD packets are transmitted can be configured for a link that has a
higher requirement for reliability. A long interval at which BFD packets are transmitted can be
configured for a link that has a lower requirement for reliability.
Issue 02 (2014-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 OSPFv3 Configuration
*
445