Huawei Quidway NetEngine80E Configuration Manual page 701
Universal service router, ip routing
Hide thumbs
Also See for Quidway NetEngine80E:
- Configuration manual - reliability (1432 pages) ,
- Configuration manual (341 pages) ,
- Installation manual (169 pages)
Advertisement
HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Figure 7-11 Configuring local MT
172.16.1.2/24
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Assign an IP address for each interface and enable IS-IS.
Issue 02 (2014-09-30)
Client
GE1/0/0
172.16.1.1/24
Router-id
RouterA
1.1.1.1
GE2/0/0
10.0.0.1/24
GE1/0/0
10.0.0.2/24
RouterB
Router-id
2.2.2.2
GE2/0/0
10.0.1.2/24
Tunnel1/0/0
10.0.1.1/24
Enable basic IS-IS functions on each router.
Configure the Protocol Independent Multicast Sparse Mode (PIM-SM).
Configure an MPLS Resource Reservation Protocol (RSVP) TE tunnel and enable IGP
Shortcut.
Enable local MT.
IP address of each router interface is shown in
originating system ID is 0000.0000.0001 and is incremental, and the routers are Level-2
routers.
Tunnel interface is TE tunnel 1/0/0, the tunnel interface borrows the IP address of Loopback
0, the tunnel encapsulation protocol is MPLS TE, the destination address is 4.4.4.4, the
tunnel ID is 100, and the tunnel signaling protocol is RSVP-TE.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Tunnel1/0/0
RouterC
Router-id
3.3.3.3
GE1/0/0
GE2/0/0
10.0.2.2/24
7 IS-IS Configuration
Server
192.168.3.2/24
GE2/0/0
192.168.3.1/24
Router-id
RouterE
5.5.5.5
GE1/0/0
10.0.3.3/24
GE1/0/0
10.0.3.1/24
RouterD
Router-id
4.4.4.4
GE2/0/0
10.0.2.1/24
Figure
7-11. The area address is 10, the
Join
Multicast
Packets
676
Hide quick links:
Advertisement
