Huawei Quidway NetEngine80E Configuration Manual page 190

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
l
l
Perform the following steps on the RIP router:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run any of the following commands as required:
l Based on the basic ACL:
l Based on the named advanced ACL:
l Based on the IP prefix: rip metricin { value | ip-prefix ip-prefix-name value1 }
Step 4 Run any of the following commands as required:
l Based on the basic ACL:
Issue 02 (2014-09-30)
The rip metricin command is used to add an additional metric to an incoming route. After
this route is added to the routing table, its metric in the routing table changes.Running this
command affects route selection on the local device and other devices on the network.
The rip metricout command is used to add an additional metric to an outgoing route. When
this route is advertised, an additional metric is added to this route, but the metric of the
route in the routing table does not change. Running this command does not affect route
selection on the local device or other devices on the network.
1. Run rip metricin { value | { acl-number | acl-name acl-name } value1 }, the metric
added to an incoming route is set.
2. Run quit, return to the system view.
3. Run acl { [ number ] acl-number1 | name acl-name basic [ number acl-number2 ] }
[ match-order { auto | config } ], the basic ACL view is displayed.
4. Run rule [ rule-id ] { deny | permit } [ fragment-type fragment-type-name | source
{ source-ip-address source-wildcard | any } | time-range time-name | vpn-instance
vpn-instance-name ]
1. Run rip metricin { value | acl-name acl-name value1 }, the metric added to an incoming
route is set.
2. Run quit, return to the system view.
3. Run acl name acl-name advance [ number acl-number2 ] [ match-order { auto |
config } ], the basic ACL view is displayed.
4. Run rule [ rule-id ] { deny | permit } protocol [ source { source-ip-address source-
wildcard | any } | time-range time-name ]
NOTE
You can specify the value of the metricin to be added to the RIP route that passes the filtering policy by
specifying value1 through an ACL or an IP prefix list. If a RIP route does not pass the filtering, its metric
is not incremented.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
*
, a rule is configured for the basic ACL.
*
, a rule is configured for the basic ACL.
3 RIP Configuration
165