Huawei Quidway NetEngine80E Configuration Manual page 235

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Networking Requirements
As shown in
exchanges routing information with Router A and Router C through RIP 100 and RIP 200
respectively.
It is required that the two RIP processes of Router B import RIP routes from each other. The
cost of the routes imported from RIP 200 defaults to 3.
In addition, a filtering policy needs to be configured on Router B to filter out the route
192.168.4.0/24 imported from RIP 200 and prevent it from being advertised to Router A.
Figure 3-4 Networking diagram for configuring RIP to import external routes
RouterA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
Procedure
Step 1 Configure an IP address for each interface.
Issue 02 (2014-09-30)
Figure 3-4, two RIP processes, RIP 100 and RIP 200, run on Router B. Router B
GE2/0/0
192.168.0.1/24
POS1/0/0
192.168.1.1/24
POS1/0/0
192.168.1.2/24
RIP 100
Enable RIP 100 and RIP 200 on each router and specify network segments.
Configure the two RIP processes on Router B to import routes from each other and set the
default cost of the routes imported from RIP 200 to 3.
Configure an ACL on Router B to filter the routes imported from RIP 200.
RIP 100 and network segments (192.168.1.0 and 192.168.0.0) on Router A
RIP 100, RIP 200, and network segments (192.168.1.0 and 192.168.2.0) on Router B
RIP 200 and network segments (192.168.2.0, 192.168.3.0, and 192.168.4.0) on Router C
Default cost of the routes imported by Router B from RIP 200, which is 3
ACL 2000 that is used to deny the route with the source network segment being 192.168.4.0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
POS1/0/0
192.168.2.2/24
POS2/0/0
192.168.2.1/24
RouterB RIP 200
3 RIP Configuration
GE2/0/0
192.168.3.1/24
GE3/0/0
RouterC 192.168.4.1/24
210