Huawei Quidway NetEngine80E Configuration Manual page 376

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Configure an IP address for each interface.
This example assumes that you know the configuration method and no details are provided here.
Step 2 Configure basic OSPF functions.
# Configure Router A.
[RouterA] router id 1.1.1.1
[RouterA] ospf
[RouterA-ospf-1] area 0
[RouterA-ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255
[RouterA-ospf-1-area-0.0.0.0] quit
# Configure Router B.
[RouterB] router id 2.2.2.2
[RouterB] ospf
[RouterB-ospf-1] area 0
[RouterB-ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255
[RouterB-ospf-1-area-0.0.0.0] quit
# Configure Router C.
[RouterC] router id 3.3.3.3
[RouterC] ospf
[RouterC-ospf-1] area 0
[RouterC-ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255
[RouterC-ospf-1-area-0.0.0.0] quit
# Configure Router D.
[RouterD] router id 4.4.4.4
[RouterD] ospf
[RouterD-ospf-1] area 0
[RouterD-ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255
[RouterD-ospf-1-area-0.0.0.0] quit
# View the DR/BDR status.
[RouterA] display ospf peer
Area 0.0.0.0 interface 192.168.1.1(GigabitEthernet1/0/0)'s neighbors
Router ID: 2.2.2.2
State: Full
DR: 192.168.1.4
Issue 02 (2014-09-30)
Configure the DR priority of the interface and check the DR/BDR status.
The router ID of Router A is 1.1.1.1 and the DR priority is 100.
The router ID of Router B is 2.2.2.2 and the DR priority is 0.
The router ID of Router C is 3.3.3.3 and the DR priority is 2.
The router ID of Router D is 4.4.4.4 and the DR priority is 1.
OSPF Process 1 with Router ID 1.1.1.1
Neighbors
Mode:Nbr is
BDR: 192.168.1.3
Dead timer due in 32
Retrans timer interval: 5
Neighbor is up for 00:04:21
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Address: 192.168.1.2
Master Priority: 1
MTU: 0
sec
5 OSPF Configuration
351