Example For Configuring Ospfv3 Dr Election - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
l
l

6.16.2 Example for Configuring OSPFv3 DR Election

This part provides an example for setting the DR priority on an interface for DR election on a
broadcast network.
Networking Requirements
In Figure
elected as the DR. Router C has the second highest priority, so it is elected as the BDR. The
priority of Router B is 0 so that it cannot be elected as the DR. Router D does not have a priority
and the priority is 1 by default.
Issue 02 (2014-09-30)
router-id 2.2.2.2
#
return
Configuration file of Router C
#
sysname RouterC
#
ipv6
#
interface Pos1/0/0
link-protocol ppp
undo shutdown
ipv6 enable
ipv6 address 2001:DB8:1::2/64
ospfv3 1 area 0.0.0.0
#
interface Pos2/0/0
link-protocol ppp
undo shutdown
ipv6 enable
ipv6 address 2001:DB8:3::1/64
ospfv3 1 area 0.0.0.2
#
ospfv3 1
router-id 3.3.3.3
area 0.0.0.2
stub no-summary
default-cost 10
#
return
Configuration file of Router D
#
sysname RouterD
#
ipv6
#
interface Pos2/0/0
link-protocol ppp
undo shutdown
ipv6 enable
ipv6 address 2001:DB8:3::2/64
ospfv3 1 area 0.0.0.2
#
ospfv3 1
router-id 4.4.4.4
area 0.0.0.2
stub
#
return
6-2, Router A has a DR priority of 100, which is the highest in the network, so it is
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 OSPFv3 Configuration
470