Huawei Quidway NetEngine80E Configuration Manual page 726

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Parameter
IS-IS process ID
Level
NET
IS-IS name
Metric type
Metric value
Other parameters
Table 7-6 MPLS parameter
Parameter
LSR ID
Tunnel interface number
Tunnel interface description
Tunnel interface address
Tunnel ID
Name of the explicit path
Tunnel metric value
Tunnel bandwidth
Name of the LDP peer
Other parameters
Issue 02 (2014-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Value
64
2
In the format of Area-ID.System-ID.00
l Area-ID: 86.0010
l System-ID: is based on the expansion of
the IP address of Loopback 0. For
example, if the IP address of Loopback 0
is 1.1.1.1, the system ID becomes
0010.0100.1001.
Same as the device name
Wide
Physical interface: 5
Tunnel interface: 6
Default values
Value
IP address of Loopback 0
Number of the physical outbound interface of
the tunnel
to_destination node
IP address of Loopback 0
100
Tunnel description
Smaller than the metric value of the primary
path and greater than the metric values of
other paths so that the tunnel can become the
backup path and LDP over TE can be
implemented
200 Mbit/s
to_destination node
Default values
7 IS-IS Configuration
701