Configuring Basic Bgp4+ Functions - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
BGP4+ does not support summary automatic and MP-BGP.

9.2 Configuring Basic BGP4+ Functions

Before building BGP4+ networks, you need to configure basic BGP4+ functions.
9.2.1 Before You Start
Before configuring basic BGP4+ functions, familiarize yourself with the usage scenario,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Applicable Environment
BGP4+ is configured in an IPv6 network.
Pre-configuration Tasks
Before configuring basic BGP4+ functions, complete the following tasks:
l
l
Data Preparation
To configure BGP4+, you need the following data.
No.
1
2
3
9.2.2 Starting a BGP Process
Starting a BGP4+ process is a prerequisite for configuring basic BGP4+ functions. When starting
a BGP4+ process, you need to specify the number of the AS that the device belongs to.
Context
Perform the following steps on the router on which the BGP4+ connection needs to be set up:
Procedure
Step 1 Run:
system-view
Issue 02 (2014-09-30)
Enabling IPv6
Configuring link layer protocol parameters and IPv6 addresses for interfaces to make link
layers of the interfaces Up
Data
Local AS number and Router ID
IPv6 address and AS number of the peer
(Optional) Interfaces that set up the BGP4+ session
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 BGP4+ Configuration
1048