Is-Is Configuration - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
About This Chapter
This chapter describes the basic principle of IS-IS and procedures for configuring IS-IS, and
provides configuration examples.
7.1 Introduction
By building IS-IS networks, you can enable IS-IS to discover and calculate routes in ASs.
7.2 Configuring Basic IPv4 IS-IS Functions
This section describes the procedures for configuring basic IPv4 IS-IS functions, including the
procedures for configuring IS-IS processes and interfaces, to implement communication
between nodes on an IPv4 IS-IS network.
7.3 Establishing or Maintaining IS-IS Neighbor Relationships or Adjacencies
This section describes how to configure the parameters that affect the IS-IS neighbor
relationship.
7.4 Configuring IPv4 IS-IS Route Selection
Configuring IS-IS route selection can achieve refined control over route selection.
7.5 Configuring IPv4 IS-IS Route Summarization
To improve the route searching efficiency and simplify route management on a large-scale IS-
IS network, configure IS-IS route summarization to reduce the number of IS-IS routes in a
routing table.
7.6 Configuring IPv4 IS-IS to Interact with Other Routing Protocols
If other routing protocols are configured on an IS-IS network, you need to configure IS-IS to
interact with these protocols to ensure successful communication between them.
7.7 Configuring the IPv4 IS-IS Route Convergence Speed
Accelerating IS-IS route convergence can improve the fault location efficiency and improve the
network reliability.
7.8 Configuring Static BFD for IPv4 IS-IS
BFD can provide link failure detection featuring light load and high speed (at the millisecond
level). Static BFD can be configured to monitor IS-IS links.
7.9 Configuring Dynamic BFD for IPv4 IS-IS
Dynamic BFD for IPv4 IS-IS can accelerate IS-IS route convergence.
Issue 02 (2014-09-30)
7
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.

IS-IS Configuration

7 IS-IS Configuration
493