Checking The Configurations - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
l
----End

7.12.6 Checking the Configurations

After basic IPv6 IS-IS functions are configured, you can view information about IS-IS neighbors,
interfaces, and routes.
Prerequisites
Basic IPv6 IS-IS functions have been configured.
Procedure
Step 1 Run the display isis name-table [ process-id | vpn-instance vpn-instance-name ] command to
check the mapping from the name of the local device to the system ID.
Step 2 Run the display isis peer [ verbose ] [ process-id | vpn-instance vpn-instance-name ] command
to check information about IS-IS neighbors.
Step 3 Run the display isis interface [ [ verbose | traffic-eng ]
instance vpn-instance-name ] command to check information about IS-IS interfaces.
Step 4 Run the display isis route [ process-id | vpn-instance vpn-instance-name ] ipv6 [ topology
topology-name ] [ verbose | [ level-1 | level-2 ] | ipv6-address [ prefix-length ] ]
command to check information about IS-IS routes.
----End
Example
Run the display isis name-table command to view the mappings between host names and system
IDs.
<HUAWEI> display isis name-table
Issue 02 (2014-09-30)
status of the IS-IS interface goes Down and the route to the network segment where
the interface resides is not advertised through LSPs.
Configure IS-IS not to check whether the IP addresses of received Hello packets are on the
same network segment.

1.

Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
isis peer-ip-ignore
IS-IS is configured not to check whether the IP addresses of received Hello packets
are on the same network segment.
Name table information for ISIS(1)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 IS-IS Configuration
*
| tunnel ] [ process-id | vpn-
*
[ | count ]
581