Huawei Quidway NetEngine80E Configuration Manual page 496

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Figure 6-2 Networking diagram of configuring OSPFv3 DR election
2001:DB8::1/64
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Assign an IPv6 address for each interface.
For configuration details, see "Configuration Files" in this section.
Step 2 Configure basic OSPFv3 functions.
# Configure Router A, enable OSPFv3, and set its router ID to 1.1.1.1.
[RouterA] ipv6
[RouterA] ospfv3
[RouterA-ospfv3-1] router-id 1.1.1.1
[RouterA-ospfv3-1] quit
[RouterA] interface GigabitEthernet 1/0/0
[RouterA-GigabitEthernet1/0/0] ospfv3 1 area 0
[RouterA-GigabitEthernet1/0/0] quit
# Configure Router B, enable OSPFv3, and set its Router ID to 2.2.2.2.
Issue 02 (2014-09-30)
RouterA
GE1/0/0
GE1/0/0
2001:DB8::3/64
RouterC
Configure the router ID on each router, enable OSPFv3, and specify the network segment.
Check the DR/BDR status with the default priority.
Configure the DR priority on the interface and check the DR/BDR status.
Router ID of Router A as 1.1.1.1; DR priority as 100
Router ID of Router B as 2.2.2.2; DR priority as 0
Router ID of Router C as 3.3.3.3; DR priority as 2
Router ID of Router D as 4.4.4.4; DR priority as 1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
RouterB
GE1/0/0
2001:DB8::2/64
GE1/0/0
2001:DB8::4/64
RouterD
6 OSPFv3 Configuration
471