Huawei Quidway NetEngine80E Configuration Manual page 963

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Route Attribute
Origin
The Origin attribute can be modified using a route-policy. In the following example, a route-
policy is configured on Router B to modify the Origin attribute, and the detailed configurations
are as follows:
#
bgp 65001
#
ipv4-family unicast
peer 10.1.3.2 route-policy for_d import
for_d to the routes learned from 10.1.3.2 and use for_d to modify the Origin
value.
#
route-policy for_d permit node 10
named for_d.
apply origin incomplete
Incomplete.
Run the display bgp routing-table [ ip-address ] command to check the configurations.
# Display the routing table of Router B.
[RouterB] display bgp routing-table
BGP Local router ID is 10.1.1.2
Status codes: * - valid, > - best, d - damped,
Total Number of Routes: 3
*>i
* i
The preceding command output shows that the route learned from Router C becomes the optimal
route.
[RouterB] display bgp routing-table 10.1.4.0
BGP local router ID : 10.1.1.2
Local AS number : 65001
Paths:
BGP routing table entry information of 10.1.4.0/30:
From: 10.1.2.2 (10.1.2.2)
Route Duration: 01h28m19s
Relay IP Nexthop: 0.0.0.0
Relay IP Out-Interface: GigabitEthernet0/0/0
Original nexthop: 10.1.2.2
Qos information : 0x0
AS-path Nil, origin incomplete, MED 0, localpref 100, pref-val 0, valid, internal,
best, select, active, pre 255
Advertised to such 1 peers:
Issue 02 (2014-09-30)
Route Learned
from Router C
Incomplete
h - history,
Origin : i - IGP, e - EGP, ? - incomplete
Network
i 10.1.2.0/30
10.1.4.0/30
2 available, 1 best, 1 select
10.1.1.1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Route Learned
from Router D
IGP
i - internal, s - suppressed, S - Stale
NextHop MED
10.1.2.2 0
10.1.2.2 0
10.1.3.2 0
8 BGP Configuration
Comparison
The route learned
from Router D is
optimal.
//Apply import policy named
//Define the route-policy
//Set the Origin type to
LocPrf PrefVal Path/Ogn
100 0 ?
100 0 ?
100 0 ?
938