Huawei Quidway NetEngine80E Configuration Manual page 595

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Procedure
l
l
----End
Example
Enable IS-IS Auto FRR, and then check and find information about the backup outbound
interface and the backup next hop of the route with the destination address as 100.1.1.0/24. The
following is the check result:
<HUAWEI> display isis route 100.1.1.1 verbose
IPV4 Dest
Admin Tag
Priority
NextHop
(B)2.0.0.2
IPV4 Dest
Admin Tag
Priority
Enable IS-IS Auto FRR, and then check and find the traffic protection type for the router with
the system ID as 0000.0000.0004. The following is the check result:
<HUAWEI> display isis spf-tree systemid 0000.0000.0004 verbose
0000.0000.0004.00
Issue 02 (2014-09-30)
Run the display isis route [ process-id | vpn-instance vpn-instance-name ] [ ipv4 ]
[ verbose | [ level-1 | level-2 ] | ip-address [ mask | mask-length ] ]
information about the primary link and backup link after IS-IS Auto FRR is enabled.
Run the display isis spf-tree [ systemid systemid | dname dname ] [ [ level-1 | level-2 ] |
*
ipv6 | verbose ] [ process-id | vpn-instance vpn-instance-name ] command to check the
traffic protection type of IS-IS Auto FRR.
: 100.1.1.0/24
: -
: Low
:
1.0.0.2
Flags: D-Direct, A-Added to URT, L-Advertised in LSPs, S-IGP Shortcut,
U-Up/Down Bit Set, C-In Computing
: 100.1.1.0/24
: -
: Low
Flags: D-Direct, A-Added to URT, L-Advertised in LSPs, S-IGP Shortcut,
U-Up/Down Bit Set, C-In Computing
ISIS(1) Level-1 Shortest Path Tree
----------------------------------
Distance : 20
Distance-URT : 20
Flags : SPT/V6_Islt
IPv4 Nexthops-URT : 1
(1) 1.0.0.2
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Route information for ISIS(1)
-----------------------------
ISIS(1) Level-1 Forwarding Table
--------------------------------
Int. Cost : 30
Src Count : 1
Interface :
GE1/0/0
GE2/0/0
ISIS(1) Level-2 Forwarding Table
--------------------------------
Int. Cost : 30
Src Count : 3
Shortest Path Tree for ISIS(1)
------------------------------
IF:GE1/0/0
7 IS-IS Configuration
*
command to check
Ext. Cost : NULL
Flags
ExitIndex :
0x00000003
0x00000004
Ext. Cost : NULL
Flags
NBR:0000.0000.0003.00
: A/-/L/-/-
: -/-/-/-/-
570