Huawei Quidway NetEngine80E Configuration Manual page 327

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
l Based on the advanced ACL:
Issue 02 (2014-09-30)
– In the configuration order, the system first matches a route with a rule that has a
smaller number and then matches the route with a rule with a larger number. Routes
can be filtered using a blacklist or a whitelist:
Route filtering using a blacklist: Configure a rule with a smaller number and specify
the action deny in this rule to filter out the unwanted routes. Then, configure another
rule with a larger number in the same ACL and specify the action permit in this rule
to receive or advertise the other routes.
Route filtering using a whitelist: Configure a rule with a smaller number and specify
the action permit in this rule to permit the routes to be received or advertised by the
system. Then, configure another rule with a larger number in the same ACL and
specify the action deny in this rule to filter out unwanted routes.
1. Run:
ospf filter-lsa-out { all | { summary [ acl acl-name ] | ase [ acl acl-
name ] | nssa [ acl acl-name ] }
The LSAs to be sent are filtered.
2. Run:
quit
Return to the system view.
3. Run:
Run acl name acl-name advance [ number acl-number2 ] [ match-order { auto |
config } ]
The basic ACL view is displayed.
4. Run:
rule [ rule-id ] { deny | permit } protocol [ source { source-ip-address
source-wildcard | any } | time-range time-name ]
The rule for the advanced ACL is configured.
When a filtering policy of a routing protocol is used to filter routes:
– If the action specified in an ACL rule is permit, a route that matches the rule will
be received or advertised by the system.
– If the action specified in an ACL rule is deny, a route that matches the rule will not
be received or advertised by the system.
– If a route has not matched any ACL rules, the route will not be received or advertised
by the system.
– If an ACL does not contain any rules, all routes matching the route-policy that
references the ACL will not be received or advertised by the system.
– If the ACL referenced by the route-policy does not exist, all routes matching the
route-policy will be received or advertised by the system.
– In the configuration order, the system first matches a route with a rule that has a
smaller number and then matches the route with a rule with a larger number. Routes
can be filtered using a blacklist or a whitelist:
Route filtering using a blacklist: Configure a rule with a smaller number and specify
the action deny in this rule to filter out the unwanted routes. Then, configure another
rule with a larger number in the same ACL and specify the action permit in this rule
to receive or advertise the other routes.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
*
}
*
5 OSPF Configuration
302