Huawei Quidway NetEngine80E Configuration Manual page 227

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
2.
3.
To configure one-arm BFD, go to Step 2. To configure two-arm BFD, go to Step 3.
Step 2 Configure one-arm BFD.
1.
2.
3.
4.
5.
Step 3 Configure two-arm BFD.
1.
2.
Issue 02 (2014-09-30)
The system view is displayed.
Run:
bfd
BFD is enabled globally.
Run:
quit
Return to the system view.
NOTE
Run:
bfd bfd-name bind peer-ip peer-ip interface interface-type interface-number
one-arm-echo
BFD is enabled between the specified interface and peer router.
If a peer IP address and a local interface are specified, BFD detects only a single-hop link,
that is, a route with the interface specified in the bfd command as the outbound interface
and with the peer IP address specified in the peer-ip command as the next-hop address.
Run:
discriminator local discr-value
The local discriminator is set.
(Optional) Run:
min-echo-rx-interval interval
The minimum interval at which BFD packets are received is configured.
Run:
commit
The configuration is committed.
Run:
quit
Return to the system view.
Run:
bfd bfd-name bind peer-ip ip-address [ interface interface-type interface-
number ]
BFD binding is created.
If a peer IP address and a local interface are specified, BFD detects only a single-hop link,
that is, a route with the interface specified in the bfd command as the outbound interface
and with the peer IP address specified in the peer-ip command as the next-hop address.
Set discriminators.
l Run:
discriminator local discr-value
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 RIP Configuration
202