Huawei Quidway NetEngine80E Configuration Manual page 404

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Figure 5-13 Configuring BFD for OSPF
GE1/0/0
1.1.1.1/24
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Assign an IP address to each interface.
Figure 5-13
configuration, see the configuration files.
Step 2 Configure basic OSPF functions.
5.2 Configuring Basic OSPF Functions
details about the configuration, see the configuration files.
# Check the OSPF neighbor relationships on Router A.
<RouterA> display ospf peer
Issue 02 (2014-09-30)
RouterA
GE2/0/0
3.3.3.1/24
GE1/0/0
1.1.1.2/24
RouterC
Enable OSPF and configure basic OSPF functions on each router.
Enable BFD for OSPF on Router A and Router B.
Router ID 1.1.1.1 of Router A; OSPF process ID 1; network segments 3.3.3.0/24 and
1.1.1.0/24 of Area 0
Router ID 2.2.2.2 of Router B; OSPF process ID 1; network segments 3.3.3.0/24, 2.2.2.0/24,
and 172.16.1.0/24 of Area 0
Router ID 3.3.3.3 of Router C; OSPF process ID 1; network segments 1.1.1.0/24 and
2.2.2.0/24 of Area 0
Minimum intervals at which BFD packets are sent and received and the local detection
multiplier on Router A and Router B.
shows how to assign an IP address to each interface. For details about the
OSPF Process 1 with Router ID 1.1.1.1
Neighbors
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
RouterB
GE3/0/0
172.16.1.1/24
GE2/0/0
3.3.3.2/24
GE1/0/0
2.2.2.2/24
GE2/0/0
2.2.2.1/24
shows how to configure basic OSPF functions. For
5 OSPF Configuration
379