Bgp Configuration - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
About This Chapter
BGP is used between ASs to transmit routing information on large-scale and complex networks.
8.1 Introduction
BGP is a dynamic routing protocol used between ASs.
8.2 Configuring the Format of BGP 4-Byte AS Numbers
You can change the format of Border Gateway Protocol (BGP) 4-byte autonomous system (AS)
numbers to your desired format.
8.3 Configuring Basic BGP Functions
Configuring basic BGP functions is the prerequisite to building a BGP network.
8.4 Configuring BGP Route Attributes
BGP has many route attributes. Configuring route attributes can change route selection results.
8.5 Configuring BGP to Advertise Routes
BGP is used to transmit routing information. BGP advertises only the wanted routes after filtering
routes to be advertised, and modifies route attributes to direct network traffic.
8.6 Configuring BGP to Receive Routes
BGP is used to transmit routing information. BGP can filter received routes to accept only the
expected routes, and can modify route attributes to direct network traffic.
8.7 Configuring a Device to Advertise BGP Supernet Unicast Routes to BGP Peers
This section describes how to configure a Border Gateway Protocol (BGP) device to advertise
BGP supernet unicast routes to BGP peers.
8.8 Configuring BGP Route Aggregation
Configuring BGP Route Aggregation on a device can reduce the sizes of routing tables on the
peers of the device.
8.9 Configuring BGP Peer Groups
Configuring BGP peer groups simplifies the BGP network configuration and improves the route
advertisement efficiency.
8.10 Configuring BGP Route Reflectors
Issue 02 (2014-09-30)
8
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.

BGP Configuration

8 BGP Configuration
734