Checking The Configurations - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
----End

7.2.6 Checking the Configurations

After configuring basic IPv4 IS-IS functions, check information about IS-IS neighbors,
interfaces, and routes.
Prerequisites
Basic IPv4 IS-IS functions have been configured.
Procedure
Step 1 Run the display isis name-table [ process-id | vpn-instance vpn-instance-name ] command to
check the mapping from the name of the local device to the system ID.
Step 2 Run the display isis peer [ verbose ] [ process-id | vpn-instance vpn-instance-name ] command
to check information about IS-IS neighbors.
Step 3 Run the display isis interface [ verbose ] [ process-id | vpn-instance vpn-instance-name ]
command to check information about IS-IS interfaces.
Step 4 Run the display isis route [ process-id | vpn-instance vpn-instance-name ] [ ipv4 ] [ verbose |
[ level-1 | level-2 ] | ip-address [ mask | mask-length ] ]
IS-IS routes.
Step 5 Run the display isis cost interface interface-type interface-number to display costs of an
interface and how they are generated.
----End
Example
Run the display isis name-table command to view the mappings between host names and system
IDs.
<HUAWEI> display isis name-table
System ID

-------------------------------------------------------------------------------

1111.1111.1111
2222.2222.2222
Run the display isis peer command. The command output shows the status of an IS-IS neighbor,
DeviceB. System Id is displayed as DeviceB.
<HUAWEI> display isis peer
Issue 02 (2014-09-30)
interface interface-type interface-number
The interface view is displayed.
3. Run:
isis peer-ip-ignore
IS-IS is configured not to check whether the IP addresses of received Hello packets
are on the same network segment.
Name table information for ISIS(1)
Hostname
DeviceA
DeviceB
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 IS-IS Configuration
*
command to check information about
Type
DYNAMIC
DYNAMIC
515