Huawei Quidway NetEngine80E Configuration Manual page 629

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Example
Run the display isis lsdb verbose command on the device that generates a default route. The
command output shows that IS-IS has advertised a default route.
<HUAWEI> display isis lsdb verbose
LSPID
-------------------------------------------------------------------------------
1111.1111.1111.00-00
SOURCE
NLPID
AREA ADDR
INTF ADDR V6 12:1::1
Topology
NBR
IPV6
2222.2222.2222.00-00* 0x0000000f
SOURCE
NLPID
AREA ADDR
INTF ADDR V6 12:1::2
Topology
NBR
IPV6
2222.2222.2222.00-01* 0x00000003
SOURCE
IPV6
2222.2222.2222.01-00* 0x00000002
SOURCE
NLPID
NBR
NBR
3333.3333.3333.00-00
SOURCE
NLPID
AREA ADDR
INTF ADDR
NBR
IP-Internal
Total LSP(s): 5
Run the display isis route command on the device that receives the default route. The command
output shows that the default route ::/0 with a next-hop address of FE80::7D7E:0:22D7:1 has
been imported into the Level-2 IS-IS routing table.
<HUAWEI> display isis route
Issue 02 (2014-09-30)
Database information for ISIS(1)
--------------------------------
Seq Num
0x0000000a
1111.1111.1111.00
IPV6
10
Standard
ID 2222.2222.2222.01
12:1::/64
2222.2222.2222.00
IPV6
10
Standard
ID 2222.2222.2222.01
12:1::/64
2222.2222.2222.00
::/0
2222.2222.2222.01
IPV6
ID 2222.2222.2222.00
ID 1111.1111.1111.00
0x00000004
3333.3333.3333.00
IPV4
10
20.1.1.2
ID 2222.2222.2222.00
20.1.1.0
*(In TLV)-Leaking Route, *(By LSPID)-Self LSP, +-Self LSP(Extended),
ATT-Attached, P-Partition, OL-Overload
ISIS(1) Level-2 Forwarding Table
--------------------------------
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Level-2 Link State Database
Checksum
0xfab7
COST: 10
0xe95c
COST: 10
0x7cbc
0xe1ea
COST: 0
COST: 0
0xac80
COST: 10
255.255.255.0
Route information for ISIS(1)
-----------------------------
7 IS-IS Configuration
Holdtime Length
1120 86
COST: 10
1138 86
COST: 10
1195 35
COST: 0
1138 55
231 68
COST: 10
ATT/P/OL
0/0/0
0/0/0
0/0/0
0/0/0
0/0/0
604