Huawei Quidway NetEngine80E Configuration Manual page 378

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
DR: 192.168.1.4
Step 4 Restart OSPF processes.
In the user view of each router, run the reset ospf1process command to restart the OSPF process.
Step 5 View the configuration.
# View the status of OSPF neighbors.
[RouterD] display ospf peer
Area 0.0.0.0 interface 192.168.1.4(GigabitEthernet1/0/0)'s neighbors
Router ID: 1.1.1.1
State: Full
DR: 192.168.1.1
Router ID: 2.2.2.2
State: Full
DR: 192.168.1.1
Router ID: 3.3.3.3
State: Full
DR: 192.168.1.1
# View the status of the OSPF interface.
[RouterA] display ospf interface
Area: 0.0.0.0
IP Address
192.168.1.1
[RouterB] display ospf interface
Area: 0.0.0.0
IP Address
192.168.1.2
If all neighbors are in the Full state, it indicates that Router A establishes the neighbor
relationship with its neighbor. If the neighbor stays "2-Way", it indicates both of them are not
the DR or BDR. Therefore, they need not exchange LSAs.
If the status of the OSPF interface is DROther, it indicates that it is neither DR nor BDR.
----End
Issue 02 (2014-09-30)
BDR: 192.168.1.3
Dead timer due in 33
Retrans timer interval: 5
Neighbor is up for 00:11:15
Authentication Sequence: [ 0 ]
OSPF Process 1 with Router ID 4.4.4.4
Neighbors
Mode:Nbr is
BDR: 192.168.1.3
Dead timer due in 35
Retrans timer interval: 5
Neighbor is up for 00:07:19
Authentication Sequence: [ 0 ]
Mode:Nbr is
BDR: 192.168.1.3
Dead timer due in 35
Retrans timer interval: 5
Neighbor is up for 00:07:19
Authentication Sequence: [ 0 ]
Mode:Nbr is
BDR: 192.168.1.3
Dead timer due in 37
Retrans timer interval: 5
Neighbor is up for 00:07:17
Authentication Sequence: [ 0 ]
OSPF Process 1 with Router ID 1.1.1.1
Interfaces
Type
Broadcast
OSPF Process 1 with Router ID 2.2.2.2
Interfaces
Type
Broadcast
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
MTU: 0
sec
Address: 192.168.1.1
Slave Priority: 100
MTU: 0
sec
Address: 192.168.1.2
Master Priority: 0
MTU: 0
sec
Address: 192.168.1.3
Slave Priority: 2
MTU: 0
sec
(MPLS TE not enabled)
State Cost Pri
DR 1 100
(MPLS TE not enabled)
State Cost Pri
DROther 1 0
5 OSPF Configuration
DR BDR
192.168.1.1 192.168.1.3
DR BDR
192.168.1.1 192.168.1.3
353