Huawei Quidway NetEngine80E Configuration Manual page 345

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bfd
BFD is globally configured.
Step 3 Run:
quit
Return to the system view.
Step 4 Run:
ospf [ process-id ]
The OSPF process view is displayed.
Step 5 Run:
bfd all-interfaces enable
BFD for OSPF is configured. The default parameter values are used to create a BFD session.
If all the interfaces in a certain process are configured with BFD and their neighbor relationships
are in the Full state, OSPF creates BFD sessions with default parameter values on all the
interfaces in the process.
Step 6 (Optional) Run:
bfd all-interfaces { min-rx-interval receive-interval | min-tx-interval transmit-
interval | detect-multiplier multiplier-value | frr-binding
BFD session parameters are modified.
You can skip this step. The default interval at which BFD packets are transmitted and the default
detection multiplier are recommended.
The parameters are configured based on the network status and network reliability requirements.
A short interval at which BFD packets are transmitted can be configured for a link that has a
higher requirement for reliability. A long interval at which BFD packets are transmitted can be
configured for a link that has a lower requirement for reliability.
Issue 02 (2014-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 OSPF Configuration
*
}
320