Checking The Configurations - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
interface from being a part of a backup link and being burdened after FRR switches traffic to
the backup link.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The view of the OSPFv3 IP FRR-enabled interface is displayed.
Step 3 Run:
ospfv3 frr block
The OSPFv3 IP FRR function is disabled on the specified interface.
----End

6.11.5 Checking the Configurations

After configuring OSPFv3 IP FRR, you can view route information.
Prerequisites
All OSPFv3 IP FRR configurations have been configured.
Procedure
l
----End
Example
View the routes to the specified OSPFv3 device.
<HUAWEI> display ospfv3 routing verbose
Codes : E2 - Type 2 External, E1 - Type 1 External, IA - Inter-Area,
N - NSSA, U - Uninstalled, D - Denied by Import Policy
Destination
Metric
Nexthop
GigabitEthernet0/0/1
Backup Nexthop: FE80::2E0:D0FF:FE02:8142
GigabitEthernet0/0/0
Backup Type
The preceding display shows that a backup route is generated on device, including information
about the backup next hop: Backup NextHop is address of the backup next hop, Backup
Interface is outbound interface of the backup next hop, Backup Type is type of the backup next
hop.
Issue 02 (2014-09-30)
Run the display ospfv3 [ process-id ] routing verbose command to check information
about the primary and backup links after OSPFv3 IP FRR is enabled.
: CC::

: 21

: FE80::2E0:50FF:FE79:8242
: LINK PROTECT
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 OSPFv3 Configuration
Prefix Length : 64
Type : INTRA-AREA
Nexthop Interface:
Backup Interface :
Flags : N|U
452