Huawei Quidway NetEngine80E Configuration Manual page 491

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Figure 6-1 Networking diagram of configuring OSPFv3 areas
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Assign an IPv6 address for each interface.
For configuration details, see "Configuration Files" in this section.
Step 2 Configure basic OSPFv3 functions.
# Configure Router A.
[RouterA] ipv6
[RouterA] ospfv3
[RouterA-ospfv3-1] router-id 1.1.1.1
[RouterA-ospfv3-1] quit
Issue 02 (2014-09-30)
RouterB
POS2/0/0
2001:DB8:2::1/64
POS2/0/0
2001:DB8:2::2/64
RouterA
GE3/0/0
2001:DB8:4::1/64
Area1
Enable basic OSPFv3 function on each router.
Configure Area 2 as a stub area and check the OSPFv3 routing table of Router D.
Configure Area 2 as a totally stub area and check the OSPFv3 routing table of Router D.
Router ID of Router A as 1.1.1.1 of Area 1
Router ID of Router B as 2.2.2.2 of Areas 0 and 1
Router ID of Router C as 3.3.3.3 of Areas 0 and 2
Router ID of Router D as 4.4.4.4 of Area 2
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Area0
POS1/0/0
2001:DB8:1::1/64
POS1/0/0
2001:DB8:1::2/64
6 OSPFv3 Configuration
RouterC
POS2/0/0
2001:DB8:3::1/64
POS2/0/0
2001:DB8:3::2/64
RouterD
Area2
Stub
466