Huawei Quidway NetEngine80E Configuration Manual page 224

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Pre-configuration Tasks
Before configuring BFD for RIP, complete the following tasks:
l
l
Data Preparation
To complete the configuration, you need the following data.
No.
1
2
3
Procedure
l
Issue 02 (2014-09-30)
Assigning an IP address to each interface to ensure reachability between neighboring nodes
at the network layer
Configuring Basic RIP Functions
Data
ID of a RIP process to be enabled with BFD
Type and number of an interface to be enabled with BFD
(Optional) BFD session parameter values
NOTE
Default BFD session parameter values are recommended.
Enable BFD in a RIP process.
1. Run:
system-view
The system view is displayed.
2. Run:
bfd
BFD is enabled globally.
3. Run:
quit
Return to the system view.
4. Run:
rip process-id
The RIP view is displayed.
5. Run:
bfd all-interfaces enable
BFD is enabled in the RIP process to establish a BFD session.
If BFD is enabled globally, RIP will use default BFD parameters to establish BFD
sessions on all the interfaces where RIP neighbor relationships are in the Up state.
6. (Optional) Run:
bfd all-interfaces
min-transmit-value | detect-multiplier detect-multiplier-value }
The values of BFD parameters used to establish the BFD session are set.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
{ min-rx-interval min-receive-value | min-tx-interval
3 RIP Configuration
*
199