Huawei Quidway NetEngine80E Configuration Manual page 284

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
By configuring local multicast topology (MT), you can create a proper routing table for multicast
traffic when multicast and an MPLS TE tunnel are configured on a network.
5.10 Configuring BFD for OSPF
After BFD for OSPF is enabled, when a link fails, the router rapidly detects the failure, notifies
the OSPF process or interface of the fault, and instructs OSPF to recalculate routes. This speeds
up OSPF network convergence.
5.11 Configuring OSPF IP FRR
With OSPF IP FRR, devices can rapidly switch traffic from faulty links to backup links without
interrupting traffic. This protects traffic and greatly improves the reliability of OSPF networks.
5.12 Configuring OSPF GR
This section describes how to configure OSPF GR to avoid traffic interruption and route flapping
caused by the active/standby switchover.
5.13 Improving Security of an OSPF Network
On a network demanding high security, you can adopt the GTSM mechanism and configure
OSPF authentication to improve the security of the OSPF network.
5.14 Configuring the Network Management Function of OSPF
OSPF supports the network management function. You can bind the OSPF MIB to a certain
OSPF process, and configure the trap function and log function.
5.15 Maintaining OSPF
Maintaining OSPF involves resetting OSPF and clearing OSPF statistics.
5.16 Configuration Examples
This section provides several configuration examples of OSPF together with the Networking
diagram. The configuration examples explain networking requirements, configuration notes,
and configuration roadmap.
Issue 02 (2014-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 OSPF Configuration
259