Huawei Quidway NetEngine80E Configuration Manual page 502

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Step 3 Configure a virtual link in Area 1 on Router B and Router C.
# Configure Router B.
[RouterB] ospfv3
[RouterB-ospfv3-1] area 1
[RouterB-ospfv3-1-area-0.0.0.1] vlink-peer 3.3.3.3
[RouterB-ospfv3-1-area-0.0.0.1] quit
# Configure Router C.
[RouterC] ospfv3
[RouterC-ospfv3-1] area 1
[RouterC-ospfv3-1-area-0.0.0.1] vlink-peer 2.2.2.2
[RouterC-ospfv3-1-area-0.0.0.1] quit
Step 4 Verify the configuration.
# Display the OSPFv3 routing table of Router C.
[RouterC] display ospfv3 routing
OSPFv3 Process (1)
IA 2001:DB8:2::/64
----End
Configuration Files
l
l
Issue 02 (2014-09-30)
directly-connected, Pos2/0/0
Destination
Next-hop
2001:DB8:1::/64
directly-connected, Pos1/0/0
2001:DB8:1::1/128
via FE80::4D67:0:EB7D:2, Pos1/0/0
2001:DB8:1::2/128
directly-connected, Pos1/0/0
via FE80::4D67:0:EB7D:2, Pos1/0/0
2001:DB8:3::/64
directly-connected, Pos2/0/0
NOTE
After a virtual link is configured, Area 2 is connected to Area 0 through the virtual link. So the route to
Area 2 is contained in the routing table of Router C.
Configuration file of Router A
#
sysname RouterA
#
ipv6
#
interface Pos1/0/0
link-protocol ppp
undo shutdown
ipv6 enable
ipv6 address 2001:DB8:2::2/64
ospfv3 1 area 0.0.0.2
#
ospfv3 1
router-id 1.1.1.1
#
return
Configuration file of Router B
#
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 OSPFv3 Configuration
Metric
1
1
1
2
1
477