Huawei Quidway NetEngine80E Configuration Manual page 196

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Context
Perform the following steps on the RIP router:
Procedure
l
l
----End
Issue 02 (2014-09-30)
Disable an interface from sending RIP Update packets in a RIP process (with a high
priority).
1. Run:
system-view
The system view is displayed.
2. Run:
rip [ process-id ]
The RIP process is enabled, and the RIP view is displayed.
3. Run:
silent-interface interface-type interface-number
A specified interface is disabled from sending RIP Update packets.
You can configure an interface as a silent interface so that it only receives RIP Update
packets to update its routing table.
NOTE
You can run the silent-interface all command to disable all RIP interfaces from sending RIP
Update packets.
The silent-interface command takes precedence over the rip output command configured in
the interface view. By default, an interface can both send and receive RIP Update packets.
Disable an interface from sending RIP Update packets in the interface view (with a low
priority).
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
undo rip output
The interface is disabled from sending RIP Update packets.
By running this command, you can specify whether to send RIP Update packets on
an interface. The silent-interface command takes precedence over the undo rip
output command. By default, an interface is allowed to send RIP Update packets.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 RIP Configuration
171