HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
The system view is displayed.
Step 2 Run:
bgp { as-number-plain | as-number-dot }
The BGP view is displayed.
Step 3 Run:
ipv6-family unicast
The BGP IPv6 unicast address family view is displayed.
Step 4 Run:
peer { ipv6-address | group-name } default-route-advertise [ route-policy route-
policy-name ]
Default routes are advertised to peers (or a peer group).
If route-policy route-policy-name is set, the BGP device changes attributes of a default route
based on the specified route-policy.
----End
9.4.6 Configuring the Policy for Advertising BGP4+ Routing
Information
After the policy for advertising routes is configured, only the routes that match the policy can
be added to the local BGP4+ routing table and advertised to BGP4+ peers.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp { as-number-plain | as-number-dot }
The BGP view is displayed.
Step 3 Run:
ipv6-family [ unicast ]
The BGP IPv6 unicast address family view is displayed.
Step 4 Run the following command to configure the outbound routing policy based on the following
different filters:
l Based on the export policy
Issue 02 (2014-09-30)
NOTE
After the command peer default-route-advertise is run, the router sends a default route with the local
address as the next hop to the specified peer, regardless of whether there are default routes in the routing
table.
Run:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 BGP4+ Configuration
1065