Checking The Configurations - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
The length of time the GR restarter and GR helper wait for End-of-RIB messages is set.
By default, the time for waiting for End-Of-RIB messages is 600s.
----End

8.22.4 Checking the Configurations

After BGP GR is configured, you can view the BGP GR status.
Prerequisites
The BGP GR configurations have been configured.
Procedure
l
----End
Example
# Run the display bgp peer ipv4-address verbose command to view the BGP GR status. For
example:
<HUAWEI> display bgp peer 10.1.3.2 verbose
Received: Total 3 messages
Sent: Total 5 messages
Issue 02 (2014-09-30)
NOTE
You can adjust BGP GR session parameter values as needed, but default values are recommended.
Run the display bgp peer verbose command to check the BGP GR status.
BGP Peer is 10.1.3.2,
Type: IBGP link
BGP version 4, Remote router ID 3.3.3.3
Update-group ID: 1
BGP current state: Established, Up for 00h00m44s
BGP current event: RecvUpdate
BGP last state: OpenConfirm
BGP Peer Up count: 2
Received total routes: 0
Received active routes total: 0
Advertised total routes: 1
Port: Local - 179
Configured: Active Hold Time: 180 sec
Received : Active Hold Time: 180 sec
Negotiated: Active Hold Time: 180 sec
Peer optional capabilities:
Peer supports bgp multi-protocol extension
Peer supports bgp route refresh capability
Peer supports bgp 4-byte-as capability
Graceful Restart Capability: advertised and received
Restart Timer Value received from Peer: 150 seconds
Address families preserved for peer in GR:
IPv4 Unicast (was preserved)
Address family IPv4 Unicast: advertised and received
Update messages
Open messages
KeepAlive messages
Notification messages
Refresh messages
Update messages
Open messages
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
remote AS 65009
Remote - 52510
Keepalive Time:60 sec
Keepalive Time:60 sec

1

1
1
0
0
2
2
8 BGP Configuration
863