Huawei Quidway NetEngine80E Configuration Manual page 405

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Area 0.0.0.0 interface 1.1.1.1(GigabitEthernet1/0/0)'s neighbors
Router ID: 3.3.3.3
Area 0.0.0.0 interface 3.3.3.1(GigabitEthernet2/0/0)'s neighbors
Router ID: 2.2.2.2
The preceding command output shows that Router A, Router B, and Router C have established
OSPF neighbor relationships.
# Check the OSPF routing table on Router A.
<RouterA> display ospf routing
Routing for Network
Destination
172.16.1.0/24
3.3.3.0/24
2.2.2.0/24
2.2.2.0/24
1.1.1.0/24
Total Nets: 5
Intra Area: 5
The preceding command output shows that the next hop address of the route to 172.16.1.0/24
is 3.3.3.2, and service traffic is transmitted on the primary link from Router A to Router B.
Step 3 Configure BFD for OSPF, and set the intervals at which BFD packets are sent and received and
the local detection multiplier.
# Configure Router A.
[RouterA] bfd
[RouterA-bfd] quit
[RouterA] ospf
[RouterA-ospf-1] bfd all-interfaces enable
[RouterA-ospf-1] bfd all-interfaces min-tx-interval 500 min-rx-interval 500 detect-
multiplier 4
[RouterA-ospf-1] quit
# Configure Router B.
[RouterB] bfd
[RouterB-bfd] quit
[RouterB] ospf
[RouterB-ospf-1] bfd all-interfaces enable
[RouterB-ospf-1] bfd all-interfaces min-tx-interval 500 min-rx-interval 500 detect-
multiplier 4
[RouterB-ospf-1] quit
Issue 02 (2014-09-30)
State: Full Mode:Nbr is
DR: 1.1.1.1 BDR: 1.1.1.2
Dead timer due in 38
Retrans timer interval: 5
Neighbor is up for 00:00:15
Authentication Sequence: [ 0 ]
Neighbors
State: Full Mode:Nbr is
DR: 3.3.3.1 BDR: 3.3.3.2
Dead timer due in 25
Retrans timer interval: 5
Neighbor is up for 00:00:59
Authentication Sequence: [ 0 ]
OSPF Process 1 with Router ID 1.1.1.1
Routing Tables
Cost
2
1
2
2
1
Inter Area: 0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Address: 1.1.1.2
Master Priority: 1
MTU: 0
sec
Address: 3.3.3.2
Master Priority: 1
MTU: 0
sec
Type NextHop
Stub 3.3.3.2
Transit 3.3.3.1
Transit 3.3.3.2
Transit 1.1.1.2
Transit 1.1.1.1
ASE: 0 NSSA: 0
5 OSPF Configuration
AdvRouter Area
2.2.2.2 0.0.0.0
1.1.1.1 0.0.0.0
3.3.3.3 0.0.0.0
3.3.3.3 0.0.0.0
1.1.1.1 0.0.0.0
380