Download Print this page

Checking The Configurations - Huawei Quidway NetEngine80E Configuration Manual

Universal service router, ip routing
Hide thumbs Also See for Quidway NetEngine80E:

Advertisement

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
By default, the preference-based scheduling ratio of IPv6 routes is 8:4:2:1.
----End

7.16.6 Checking the Configurations

After the parameters specifying the IPv6 IS-IS route convergence speed are set, run the following
commands to verify that the configurations are correct.
Procedure
l
l
----End
Example
Run the display isis interface verbose command. The command output shows that GE 6/0/0
sends Hello packets at an interval of 15 ms, the number of IS-IS Hello packets sent by the
neighbor before IS-IS should declare the neighbor is invalid is 3, the sending interval for Level-1
CSNPs is 123 ms, and the minimum sending interval for LSPs is 159 ms.
<HUAWEI> display isis interface verbose
Interface
GE1/0/1
Circuit MT State
Description
SNPA Address
IP Address
IPV6 Link Local Address
IPV6 Global Address(es)
Csnp Timer Value
Hello Timer Value
DIS Hello Timer Value
Hello Multiplier Value
LSP-Throttle Timer
Cost
Ipv6 Cost
Priority
Retransmit Timer Value
Bandwidth-Value
Static Bfd
Dynamic Bfd
Dynamic IPv6 Bfd
Fast-Sense Rpr
Graceful Down
Suppress Base
IPv6 Suppress Base
Run the display isis route verbose command. The command output shows that the convergence
priority of the IS-IS route 13:1::/64 is Critical, and the convergence priority of the other IS-IS
routes is Low.
Issue 02 (2014-09-30)
Run the display isis interface [ [ verbose | traffic-eng ]
instance vpn-instance-name ] command to check IS-IS packet information.
Run the display isis route [ process-id | vpn-instance vpn-instance-name ] ipv6
[ topology topology-name ] [ verbose | [ level-1 | level-2 ] | ipv6-address [ prefix-length ] ]

*

command to check the preference of IS-IS routes.
Interface information for ISIS(1)
---------------------------------
Id
001
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
IPV4.State
IPV6.State
Down
: Standard
: GigabitEthernet1/0/0 Interface
: 00e0-ff50-8200
:
: FE80::2E0:FFFF:FE50:8200
: 13:1::2/64
:
L1
123
L2
:
L1
15
L2
:
L1
10
L2
:
L1
3
L2
:
L12
50
:
L1
10
L2
:
L1
10
L2
:
L1
64
L2
:
L12
5
:
Low 1000000000
:
NO
:
NO
:
NO
:
NO
:
NO
:
NO
:
NO
7 IS-IS Configuration
*
| tunnel ] [ process-id | vpn-
MTU
Type
Up
1497 L1/L2 No/Yes
10
15
10
3
10
10
64
High
0
DIS
615

Hide quick links:

Advertisement

loading

This manual is also suitable for:

Quidway netengine40eNe40eNe80e