Checking The Configurations - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
The system view is displayed.
Step 2 Run:
ospfv3 [ process-id ]
The OSPFv3 process view is displayed.
Step 3 Run:
area area-id
The OSPFv3 area view is displayed.
Step 4 Run:
nssa [ default-route-advertise [ cost cost | type type | tag tag ]
route | no-summary | translator-always | translator-interval translator-interval |
set-n-bit ]
An area is configured as an NSSA.
----End
Follow-up Procedure
To connect routers to an NSSA, you need to run the nssa command to configure NSSA attributes
for the area to which the routers belong.
The area may be updated after NSSA attributes are configured or deleted. Therefore, the NSSA
attributes can be re-configured or deleted only after the last update of NSSA attributes is
complete.

6.5.3 Checking the Configurations

After OSPFv3 NSSAs are configured, you can check OSPFv3 routing table information.
Prerequisites
OSPFv3 NSSAs has been configured.
Procedure
l
l
----End
6.6 Configuring OSPFv3 Route Attributes
By setting OSPFv3 route attributes, you can change OSPFv3 routing policies to meet the
requirements of complex networks.
Issue 02 (2014-09-30)

*

Run the display ospfv3 area command to check information about OSPFv3 areas.
Run the commands as follow to check the OSPFv3 routing table.
– display ospfv3 [ process-id ] routing uninstalled
– display ospfv3 [ process-id ] routing [ abr-routes | asbr-routes | statistics
[ uninstalled ] | ipv6-address prefix-length | intra-routes | inter-routes | ase-routes |
nssa-routes ]
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 OSPFv3 Configuration
*
| no-import-
418