Checking The Configurations - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing

6.2.5 Checking the Configurations

After basic OSPFv3 functions are configured, you can check OSPFv3 brief information, LSDB
information, neighbor information, and OSPFv3 routing table.
Prerequisites
The Basic OSPFv3 Functions has been configured.
Procedure
l
l
l
l
l
l
l
----End
6.3 Establishing or Maintaining OSPFv3 Neighbor
Relationship
By establishing and maintaining OSPFv3 neighbor relationships or adjacencies, you can build
OSPFv3 networks.
6.3.1 Before You Start
When setting parameters on an interface, ensure that these parameters are consistent with those
on the adjacent router.
Issue 02 (2014-09-30)
Run the display ospfv3 [ process-id ] command to check the summary information about
the OSPFv3 process.
Run the display ospfv3 [ process-id ] interface [ area area-id ] [ interface-type interface-
number ] command to check the OSPFv3 interface information.
Run the commands as follow to check the LSDB information about OSPFv3:
– display ospfv3 [ process-id ] lsdb [ area area-id ] [ originate-router advertising-
router-id | self-originate ] [ { router | network | inter-router [ asbr-router asbr-
router-id ] | { inter-prefix | nssa } [ ipv6-address prefix-length ] | link | intra-prefix |
grace } [ link-state-id ] ]
– display ospfv3 [ process-id ] lsdb [ originate-router advertising-router-id | self-
originate ] external [ ipv6-address prefix-length ] [ link-state-id ]
Run the display ospfv3 [ process-id ] [ area area-id ] peer [ interface-type interface-
number ] [ verbose ] command or display ospfv3 [ process-id ] [ area area-id ] peer
neighbor-id [ verbose ] command to check the information about the OSPFv3 neighbor.
Run the commands as follow to check the OSPFv3 routing table:
– display ospfv3 [ process-id ] routing uninstalled
– display ospfv3 [ process-id ] routing [ abr-routes | asbr-routes | statistics
[ uninstalled ] | ipv6-address prefix-length | intra-routes | inter-routes | ase-routes |
nssa-routes ]
Run the display ospfv3 [ process-id ] path command to check the paths to a destination
address.
Run the display default-parameter ospfv3 command to check the default OSPFv3
configuration.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 OSPFv3 Configuration

410