Huawei Quidway NetEngine80E Configuration Manual page 642
Universal service router, ip routing
Hide thumbs
Also See for Quidway NetEngine80E:
- Configuration manual - reliability (1432 pages) ,
- Configuration manual (341 pages) ,
- Installation manual (169 pages)
Advertisement
HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Configuration Roadmap
The configuration roadmap is as follows:
No.
1
2
3
4
5
6
You can use either of the following methods to enable BFD for IPv6 IS-IS:
l
l
Procedure
l
Issue 02 (2014-09-30)
Data
Nodes to be enabled with BFD for IPv6 IS-IS
Number of the IS-IS process to be enabled with BFD
Type and number of each interface to be enabled with BFD
Minimum interval at which BFD packets are sent
Minimum interval at which BFD packets are received
BFD detection multiplier
Enable dynamic BFD for specified IS-IS IPv6
if you need to enable dynamic BFD for IPv6 IS-IS on a large number of IS-IS interfaces.
Enable dynamic BFD for specified IPv6
need to enable dynamic BFD for IPv6 IS-IS on a small number of IS-IS interfaces.
Enable dynamic BFD for an IS-IS IPv6 process.
1.
Run:
system-view
The system view is displayed.
2.
Run:
bfd
BFD is enabled globally.
3.
Run:
quit
The system view is displayed.
4.
Run:
isis process-id
The IS-IS view is displayed.
5.
Run:
ipv6 bfd all-interfaces enable
BFD for IS-IS is enabled.
After BFD is enabled globally and the neighbor status is Up, default BFD parameters
will be used to establish BFD sessions on all interfaces.
6.
(Optional) Run:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
processes. This method is recommended
interfaces. This method is recommended if you
7 IS-IS Configuration
617
Hide quick links:
Advertisement
