Entering The Ospfv3 Area View - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
ospfv3 process-id area area-id [ instance instance-id ]
OSPFv3 is enabled on the interface.
The area ID can be a decimal integer or in the IPv4 address format, but it is displayed in the IPv4
address format.
Step 4 (Optional) Run the ospfv3 network-type { broadcast | nbma | p2mp [ non-broadcast ] |
p2p } [ instance instance-id ] command to configure the network type of an interface.
When an interface supports multi-instances, you must specify the value of instance-id when
enabling OSPFv3 on the interface. If the value of instance-id is not specified, the default value
0 is adopted. In this case, the configured network type of an interface mismatches the actual
network type of the interface. This step is mandatory in such a case.
----End

6.2.4 Entering the OSPFv3 Area View

By dividing an AS into different areas, specifying OSPFv3 interfaces, and specifying areas to
which these interfaces belong, OSPFv3 can discover and calculate routes in an AS.
Context
You must configure the devices in the same area based on the area. Otherwise, the neighbor
devices cannot exchange information with each other. The congestion of routing information or
routing loop is therefore caused.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ospfv3 [ process-id ]
The OSPFv3 view is displayed.
Step 3 Run:
area area-id
The OSPFv3 area view is displayed.
The area ID can be a decimal integer or in the IPv4 address format, but it is displayed in the IPv4
address format.
An OSPFv3 area cannot be deleted directly. Only after all the configurations in the area view
are removed and the status of the related interfaces in this area become Down, this area is
automatically removed.
----End
Issue 02 (2014-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 OSPFv3 Configuration
409