Enabling Local Mt - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Data Preparation
To configure local MT, you need the following data.
No.
1

7.20.2 Enabling Local MT

The nodes along the TE tunnel can detect multicast packets and create multicast forwarding
entries only after local MT is enabled.
Context
Perform the following steps on the router that needs to forward multicast packets and is
configured with the TE tunnel enabled with IGP-Shortcut:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
isis [ process-id ]
The IS-IS view is displayed.
Step 3 Run:
cost-style { compatible [ relax-spf-limit ] | wide | wide-compatible }
The cost type is configured.
Step 4 Run:
traffic-eng
TE is configured.
Step 5 Run:
local-mt enable
Local MT is enabled.
----End
7.20.3 Controlling the Scale of the MIGP Routing Table
By configuring the filtering policy based on multicast source addresses, you can configure
routers to add only the routes destined to the specified multicast source address to the MIGP
routing table, therefore controlling the size of the MIGP routing table.
Issue 02 (2014-09-30)
Data
Filtering list used to filter IS-IS routing information
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 IS-IS Configuration
630