Checking The Configurations - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
The system view is displayed.
Step 2 Run:
bgp { as-number-plain | as-number-dot }
The BGP view is displayed.
Step 3 Run:
ipv6-family unicast
The IPv6 unicast address family view is displayed.
Step 4 Run:
reflect change-path-attribute
You can enable the RR to modify the route attributes of the BGP4+ routes using the export
policy.
By default, you can disable the RR from modifying the route attributes using the export policy.
After you enable the reflect change-path-attribute command on an RR, the configurations of
the RR attributes modified using the export policy takes effect immediately. Perform the
following operations:
l Run the apply as-path command to modify the AS_Path attributes of BGP4+ routes.
l Run the apply comm-filter delete command to delete all community attributes from a BGP4
l Run the apply community command modifies the AS_Path attributes of BGP4+ routes.
l Run the apply cost command to modify the cost of BGP4+ routes, that is, to modify its
l Run the apply ipv6 next-hop command to modify the next hop of BGP4+ routes.
l Run the apply local-preference command to modify the local preference of BGP4+ routes.
l Run the apply origin command to modify the Origin attributes of BGP4+ routes.
l Run the apply extcommunity command to modify the extended community attributes of
----End

9.11.7 Checking the Configurations

After a BGP4+ route reflector is configured, you can check BGP4+ route information and peer
group information.
Prerequisites
A BGP4+ route reflector has been configured.
Issue 02 (2014-09-30)
+ route.
Multi_Exit Discriminator (MED).
BGP4+ routes.
NOTE
After the reflect change-path-attribute command is run on the RR, the peer route-policy export
command takes precedence over the peer next-hop-invariable and peer next-hop-local commands.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 BGP4+ Configuration

1100