Huawei Quidway NetEngine80E Configuration Manual page 637

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
l
l
----End
Issue 02 (2014-09-30)
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
isis timer lsp-throttle throttle-interval [ count count ]
The minimum interval at which LSPs are sent is set.
The count parameter specifies the maximum number of LSPs that can be sent within
the interval specified by throttle-interval. The value of count is an integer ranging
from 1 to 1000.
Enable LSP fast flooding.
1. Run:
system-view
The system view is displayed.
2. Run:
isis [ process-id ]
The IS-IS view is displayed.
3. Run:
flash-flood [ lsp-count | max-timer-interval interval | [ level-1 |
*
level-2 ] ]
The LSP fast flooding is enabled.
Running the flash-flood command speeds up LSP flooding. The lsp-count parameter
specifies the number of LSPs flooded each time, which is applicable to all interfaces.
If the number of LSPs to be sent is greater than the value of lsp-count, lsp-count takes
effect. If the number of LSPs to be sent is smaller than the value of lsp-count, LSPs
of the actual number are sent. If a timer is configured and the configured timer does
not expire before the route calculation, the LSPs are flooded immediately when being
received; otherwise, the LSPs are sent when the timer expires.
When LSP fast flooding is enabled, Level-1 LSPs and Level-2 LSPs are fast flooded
by default if no level is specified.
Set an interval at which LSPs are retransmitted over a P2P link.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
isis timer lsp-retransmit retransmit-interval
The interval at which LSPs are retransmitted over a P2P link is set.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 IS-IS Configuration
612