Huawei Quidway NetEngine80E Configuration Manual page 412

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Figure 5-15 Networking diagram of configuring OSPF GR
10.1.1.2/24
10.1.1.1/24
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure an IP address for each interface.
For configuration details, see "Configuration Files" in this section.
Step 2 Configure basic OSPF functions.
5.2 Configuring Basic OSPF Functions
details about the configuration, see the configuration files.
Step 3 (Optional) Enable forcible active/standby switchover on Router A and configure the SMB to
automatically synchronize information on the AMB.
By default, the forcible active/standby switchover is enabled.
[RouterA] slave switchover enable
Issue 02 (2014-09-30)
RouterA
POS2/0/0
10.1.2.1/24
POS1/0/0
Area1
POS1/0/0
RouterD
GE2/0/0
192.168.1.1/24
Enable OSPF to interconnect all routers.
Configure GR on RouterA, RouterB and RouterD.
IP address of each interface on the routers
OSPF process number
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
POS2/0/0
10.1.2.2/24
Area0
RouterC
GE2/0/0
192.168.2.1/24
shows how to configure basic OSPF functions. For
5 OSPF Configuration
RouterB
POS1/0/0
10.1.3.2/24
Area2
POS1/0/0
10.1.3.1/24
387