Configuring Ospfv3 Bfd Parameters At Interface Level - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
By default, OSPFv3 BFD is disabled at interface level.
----End

6.10.5 Configuring OSPFv3 BFD Parameters at Interface Level

After enabling BFD for OSPFv3 on an interface, you need to configure BFD parameters on the
interface.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
ospfv3 bfd { min-transmit-interval min-transmit-value | min-receive-interval min-
receive-value | detect-multiplier detect-multiplier-value }
id ]
OSPFv3 BFD parameters are configured at interface level.
You can skip this step. The default interval at which BFD packets are transmitted and the default
detection multiplier are recommended.
The parameters are configured based on the network status and network reliability requirements.
A short interval at which BFD packets are transmitted can be configured for a link that has a
higher requirement for reliability. A long interval at which BFD packets are transmitted can be
configured for a link that has a lower requirement for reliability.
Issue 02 (2014-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 OSPFv3 Configuration
*
[ instance instance-
447