Huawei Quidway NetEngine80E Configuration Manual page 232

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
Procedure
Step 1 Configure an IP address for each interface.
The configuration details are not described here.
Step 2 Configure basic RIP functions.
# Configure Router A.
[RouterA] rip
[RouterA-rip-1] network 192.168.1.0
[RouterA-rip-1] quit
# Configure Router B.
[RouterB] rip
[RouterB-rip-1] network 192.168.1.0
[RouterB-rip-1] network 172.16.0.0
[RouterB-rip-1] network 10.0.0.0
[RouterB-rip-1] quit
# Configure Router C.
[RouterC] rip
[RouterC-rip-1] network 172.16.0.0
[RouterC-rip-1] quit
# Configure Router D.
[RouterD] rip
[RouterD-rip-1] network 10.0.0.0
[RouterD-rip-1] quit
# Check the RIP routing table of Router A.
[RouterA] display rip 1 route
Issue 02 (2014-09-30)
Configure an IP address for each interface to ensure that neighboring nodes are reachable
at the network layer.
Enable RIP on each router and configure basic RIP functions.
Configure RIP-2 on each router and check information about classless routes.
Network segment (192.168.1.0) to be enabled with RIP on Router A
Network segments (192.168.1.0, 172.16.0.0, and 10.0.0.0) to be enabled with RIP on Router
B
Network segment (172.16.0.0) to be enabled with RIP on Router C
Network segment (10.0.0.0) to be enabled with RIP on Router D
RIP-2 on Router A, Router B, Router C, and Router D
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 RIP Configuration
207