Download Print this page

Configuring Ipv4 Is-Is Route Leaking - Huawei Quidway NetEngine80E Configuration Manual

Universal service router, ip routing
Hide thumbs Also See for Quidway NetEngine80E:

Advertisement

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Data Preparation
To configure IPv4 IS-IS route selection, you need the following data.
No.
1
2
3
4

7.4.2 Configuring IPv4 IS-IS Route Leaking

Configuring IS-IS route leaking enables you to optimize IS-IS route selection on a two-level-
area network.
Context
If multiple Level-1-2 devices in a Level-1 area are connected to devices in the Level-2 area, a
Level-1 LSP sent by each Level-1-2 device carries an ATT flag bit of 1. This Level-1 area will
have multiple routes to the Level-2 area and to other Level-1 areas.
By default, routes in a Level-1 area can be leaked into the Level-2 area so that Level-1-2 and
Level-2 devices can learn about the topology of the entire network. Devices in a Level-1 area
are unaware of the entire network topology because they only maintain LSDBs in the local
Level-1 area. Therefore, a device in a Level-1 area can forward traffic to a Level-2 device only
through the nearest Level-1-2 device. The route used may not be the optimal route to the
destination.
To enable a device in a Level-1 area to select the optimal route, configure IPv4 IS-IS route
leaking so that specified routes in the Level-2 area can be leaked into the local Level-1 area.
Routes of services deployed only in the local Level-1 area do not need to be leaked into the
Level-2 area. A policy can be configured to leak only desired routes into the Level-2 area.
Procedure
l
Issue 02 (2014-09-30)
Data
ACL for filtering routes, IP prefix list, or routing policy
Maximum number of load-balancing equal-cost IS-IS routes
Preference of the next hop
Time when an IS-IS device enters the overload state
Specify routes in the Level-2 area and other Level-1 areas that can be leaked into the local
Level-1 area.
1.
Run:
system-view
The system view is displayed.
2.
Run:
isis [ process-id ]
The IS-IS view is displayed.
3.
Run any of the following commands as required:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 IS-IS Configuration
525

Hide quick links:

Advertisement

loading

This manual is also suitable for:

Quidway netengine40eNe40eNe80e