Huawei Quidway NetEngine80E Configuration Manual page 585
Universal service router, ip routing
Hide thumbs
Also See for Quidway NetEngine80E:
- Configuration manual - reliability (1432 pages) ,
- Configuration manual (341 pages) ,
- Installation manual (169 pages)
Advertisement
HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
No.
1
2
3
You can use either of the following methods to enable dynamic BFD for IPv4 IS-IS:
l
l
Procedure
l
Issue 02 (2014-09-30)
Data
Number of the IS-IS process to be enabled with BFD
Type and number of the interface to be enabled with BFD
Parameter values of a BFD session
Enable dynamic BFD for specified IS-IS IPv4
if you need to enable dynamic BFD for IPv4 IS-IS on a large number of IS-IS interfaces.
Enable dynamic BFD for specified IPv4
need to enable dynamic BFD for IPv4 IS-IS on a small number of IS-IS interfaces.
Enable dynamic BFD for an IS-IS IPv4 process.
1.
Run:
system-view
The system view is displayed.
2.
Run:
bfd
BFD is enabled globally.
3.
Run:
quit
The system view is displayed.
4.
Run:
isis process-id
The IS-IS view is displayed.
5.
Run:
bfd all-interfaces enable
BFD for IS-IS is enabled.
After BFD is enabled globally and the neighbor status becomes Up, IS-IS adopts
default BFD parameters to establish BFD sessions on all interfaces.
6.
(Optional) Run:
bfd all-interfaces { min-rx-interval receive-interval | min-tx-interval
transmit-interval | detect-multiplier multiplier-value | frr-binding }
The parameters for establishing BFD sessions are set for all interfaces.
The command execution result is applicable to BFD session parameters on all IS-IS
interfaces.
7.
Run:
quit
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
processes. This method is recommended
interfaces. This method is recommended if you
7 IS-IS Configuration
*
560
Hide quick links:
Advertisement
