Download Print this page

Huawei Quidway NetEngine80E Configuration Manual page 697

Universal service router, ip routing
Hide thumbs Also See for Quidway NetEngine80E:

Advertisement

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
[RouterA-GigabitEthernet2/0/0] ip topology red enable
[RouterA-GigabitEthernet2/0/0] isis topology red
[RouterA-GigabitEthernet2/0/0] ipv6 topology blue enable
[RouterA-GigabitEthernet2/0/0] isis ipv6 topology blue
[RouterA-GigabitEthernet2/0/0] quit
Step 6 Verify the configuration
After the configuration is complete, run the display isis route command on the routers to view
information about the learned routes. The following example uses the display on Router D.
# Check the routing information on Router D.
[RouterD] display isis route
IPV6 Dest.
--------------------------------------------------------------------------
2008::/64
2001:db8:2::/64
2001:db8:1::/64
IPv6 routes are calculated only on the IPv6 topology. Therefore, the outbound interface of the
route from Router D to 2008::/64 is GE 2/0/0.
# Run the tracert command on Router D.
[RouterD] tracert ipv6 2008::1
traceroute to 2008::1
1 2008::1 62 ms
To make a comparison between the preceding routing information and the routing information
when an IPv4/IPv6 topology is deployed, run the following commands.
[RouterD] isis 1
[RouterD-isis-1] ipv6 enable
Configuration modifications on Router A and Router C are the same as that on Router D.
After the configuration is modified, run the display isis route command on the routers once
again to view information about the learned routes. The following example uses the display on
Router D.
# Check the routing information on Router D.
[RouterD] display isis route
IPV6 Dest.
--------------------------------------------------------------------------
2008::/64
2001:db8:2::/64
2001:db8:1::/64
The preceding output shows that the outbound interface of the route from Router D to 2008::/64
is GE 1/0/0. This is because in the SPF calculation when an IPv4/IPv6 topology is deployed, the
cost of the link passing through GE 1/0/0 to 2008::1/64 is smaller.
Issue 02 (2014-09-30)
Route information for ISIS(1)
-----------------------------
ISIS(1) Level-1 Forwarding Table
--------------------------------
ExitInterface
GE2/0/0
GE2/0/0
GE1/0/0
Flags: D-Direct, A-Added to URT, L-Advertised in LSPs, S-IGP Shortcut,
30 hops max,60 bytes packet
63 ms
31 ms
Route information for ISIS(1)
-----------------------------
ISIS(1) Level-1 Forwarding Table
--------------------------------
ExitInterface
GE1/0/0
GE2/0/0
GE1/0/0
Flags: D-Direct, A-Added to URT, L-Advertised in LSPs, S-IGP Shortcut,
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
NextHop
FE80::D11:0:36D4:1
Direct
Direct
U-Up/Down Bit Set
NextHop
FE80::200:5EFF:FE01:100
Direct
Direct
U-Up/Down Bit Set
7 IS-IS Configuration
Cost
Flags
14
A/-/-
14
D/L/-
6
D/L/-
Cost
Flags
13
A/-/-
14
D/L/-
6
D/L/-
672

Hide quick links:

Advertisement

loading

This manual is also suitable for:

Quidway netengine40eNe40eNe80e