Configuring Bgp4+ To Advertise Local Ipv6 Routes - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Pre-configuration Tasks
Before controlling the advertising and receiving of BGP4+ routing information, complete the
following tasks:
l
Data Preparation
To control the advertising and receiving of BGP4+ routing information, you need the following
data.
No.
1
2
3

9.4.2 Configuring BGP4+ to Advertise Local IPv6 Routes

The local routes to be advertised must be in the local IP routing table. You can use routing
policies to control the routes to be advertised.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp { as-number-plain | as-number-dot }
The BGP view is displayed.
Step 3 Run:
ipv6-family [ unicast ]
The BGP IPv6 unicast address family view is displayed.
Step 4 Run:
network ipv6-address prefix-length [ route-policy route-policy-name ]
The exactly-matched local IPv6 routes are advertised.
Issue 02 (2014-09-30)
If there are routers that do not support route-refresh in the network, you can run the peer
keep-all-routes command to save all route refreshment locally. Then, you can run the
refresh bgp command to soft reset the BGP4+ connections manually.
Configuring Basic BGP4+ Functions
Data
Name and process ID of the external route to be imported
Name of the filtering list used in the routing policies
Various parameters of route dampening, including half-life of a reachable route, half-
life of an unreachable route, threshold for freeing suppressed routes, threshold for
suppressing routes, and upper limit of the penalty
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 BGP4+ Configuration
1062