Huawei Quidway NetEngine80E Configuration Manual page 501

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
l
Procedure
Step 1 Assign an IP address for each interface.
For configuration details, see "Configuration Files" in this section.
Step 2 Configure basic OSPFv3 functions.
# Enable OSPFv3 on Router A and set its Router ID to 1.1.1.1.
[RouterA] ipv6
[RouterA] ospfv3
[RouterA-ospfv3-1] router-id 1.1.1.1
[RouterA-ospfv3-1] quit
[RouterA] interface Pos 1/0/0
[RouterA-Pos1/0/0] ospfv3 1 area 2
[RouterA-Pos1/0/0] quit
# Enable OSPFv3 on Router B and set its Router ID to 2.2.2.2.
[RouterB] ipv6
[RouterB] ospfv3
[RouterB-ospfv3-1] router-id 2.2.2.2
[RouterB-ospfv3-1] quit
[RouterB] interface Pos 1/0/0
[RouterB-Pos1/0/0] ospfv3 1 area 2
[RouterB-Pos1/0/0] quit
[RouterB] interface Pos 2/0/0
[RouterB-Pos2/0/0] ospfv3 1 area 1
[RouterB-Pos2/0/0] quit
# Enable OSPFv3 on Router C and set its Router ID to 3.3.3.3.
[RouterC] ipv6
[RouterC] ospfv3
[RouterC-ospfv3-1] router-id 3.3.3.3
[RouterC-ospfv3-1] quit
[RouterC] interface Pos 1/0/0
[RouterC-Pos1/0/0] ospfv3 1 area 1
[RouterC-Pos1/0/0] quit
[RouterC] interface Pos 2/0/0
[RouterC-Pos2/0/0] ospfv3 1 area 0
[RouterC-Pos2/0/0] quit
# Enable OSPFv3 on Router D and set its Router ID to 4.4.4.4.
[RouterD] ipv6
[RouterD] ospfv3
[RouterD-ospfv3-1] router-id 4.4.4.4
[RouterD-ospfv3-1] quit
[RouterD] interface Pos 1/0/0
[RouterD-Pos1/0/0] ospfv3 1 area 0
[RouterD-Pos1/0/0] quit
# Display the OSPFv3 routing table of Router C, and you can find that there is no routing
information of Area 2 in the routing table.
[RouterC] display ospfv3 routing
OSPFv3 Process (1)
Issue 02 (2014-09-30)
Router ID of Router D as 4.4.4.4 of Area 0
Destination
Next-hop
2001:DB8:1::/64
directly-connected, Pos1/0/0
2001:DB8:3::/64
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 OSPFv3 Configuration
Metric
1
1
476